True2scale True2scale Train modeling components
Suggested retail pricing for for Train Signals, Traffic Lights, etc. of the True2scale collection are listed below. Select only the components needed to satisfy the unique requirements of your layout.
(Pricing as of 03/11/2009; subject to change without notice.)
| Part No. | Component | Type | Description | Price |
| BCS3-KIT | BCS3 System installation kit | A Kit containing all three of the following components which allows you to implement the features of the BCS3 system. | 195.95 | |
| BCS3-CB | Warning Beacon Circuit Board | The circuit board with microcontroller that monitors your battery level and flashes a beacon when batteries are getting low. Also provide the on-off switch to shut down the system. | 92.95 | |
| BCS3-CJ | Battery Harness and Charging Jack | The battery harness and charge jack assembly connect up your batteries and provide a place to plug the charger into the boxcar when batteries need to be recharged. | 64.95 | |
| BCS3-CP | Charging plug for charger | A set of three ganged barrel plugs which connect to your Aristocraft charger and which plug into your boxcar when re-charging is necessary | 41.95 |
| Part No. | Component | Type | Description | Price |
| TL-C | Controller | One circuit board that controls up to three automobile intersections (Provided LED lights are used) | 52.95 | |
| TL-LH | HO scale Light post |
(to be determined) | A pair of posts, each containing one red, one yellow and one green light. Typically, four light posts are needed at an intersections, therefore two sets of these will be needed . | To be determined |
| TL-LN |
N scale Light post (pair) |
Lighted | A pair of light posts, each containing one red, one yellow and one green light. Typically, four lights are needed at an intersections, therefore two sets of these will be needed . | 22.95 |
| TL-DN |
N scale Light post (pair) |
Non-lighted | A pair of posts, which do not contain the LEDs nor the wiring to make them light. | 19.95 |
| Part No. | Component | Type | Description | Price |
| SGN-CS | Controllers | Single | One circuit board that controls only a single Signal Tower. | 14.95 |
| SGN-CD | Dual | One circuit board that controls two separate Signal Towers. | 24.95 | |
| SGN-CS4 | Controller4 | Single | One circuit board that controls only a single Signal Tower. New design. Uses either common anode or common cathode type signal towers from other manufacturers | 14.95 |
| SGN-DW2 | Detectors | Working | The normal detector for insertion into track power leads. It provides output intelligence about the presence of a train to a controller circuit board. | 11.95 |
| SGN-DD2 | Dummy | A detector for insertion into track power leads to provide only a voltage drop to maintain consistency around the layout. It does not provide output intelligence to a controller board. | 5.95 | |
| SGN-DW4 | High Power Working (DCC) | A detector for insertion into track power leads where more than five HO trains may be running at once within a single block. Same function as the Normal Detector above but allows for handling higher power. | 13.95 | |
| SGN-DD4 | High Power Dummy (DCC) | A Dummy Detector as above but for use where more than five HO trains may be running at once within a single block. | 6.95 | |
| SGN-REG | Power Regulator | A power regulator supplies regulated 5 volt power to the signal controller boards and subsequently to the LED lights on your Signal Towers. It requires 6-30 volts AC or DC input from a power source of your choice. | 18.95 |